Thursday, August 16, 2012

Do It Yourself Vcr Repair

Consider repairing your VCR instead of replacing it.


If you notice your VCR runs slow, or won't fast forward or rewind your tape, you may need to replace the drive belt. Before attempting to repair your VCR, read the warranty closely as do-it-yourself repairs may void any warranty on your VCR. Repairing a VCR is less expensive than replacing one. Check with the manufacturer of your VCR for model-specific problems or recalls before repairing your VCR. Turn your VCR off for a minute or two and try it again before attempting to repair it. This allows the VCR to reset itself. If your VCR is still running rough, it's time to repair it.


Instructions


1. Unplug your VCR and remove the bottom or top cover by unscrewing the screws holding it in place with your screwdriver. This varies depending upon your VCR. Set the screws aside in a small container to keep track of them.


2. Wrap tape around the teeth of your tweezers. This prevents the tweezers from damaging the VCR's belt. Remove the belt with your tweezers. The belt resembles a black rubber band.


3. Replace the damaged or stretched belts. Purchase a replacement kit for the model of VCR you own. Select your replacement belt a little smaller than the size you removed. This allows for the stretching of the old belt. Typically, belts 3 to 5 percent smaller work well.


4. Clean the belts with isopropyl alcohol and a cotton swab by dipping the cotton swap into the isopropyl alcohol, and rubbing the belt with it. Do not touch the belts with your fingers; instead hold them with your tweezers wrapped in tape.


5. Reinstall the VCR belts with your tweezers according to manufacturer's directions. Use your tweezers to pull the belt over any difficult-to-access pulleys. Gently stretch the belt with the teeth of the taped tweezers. Do not over stretch the belt, as this may cause the belt to break.


6. Reassemble the VCR opposite of how you disassembled it according to Step 1 by screwing the screws back in place and securing the cover.


7. Plug the VCR into your electrical outlet and insert a VCR tape to test it.







Tags: with your, your tweezers, belt with, belts with, with your tweezers, attempting repair, belts with your