Pressure gauge connected to plumbing lines
When you install new plumbing during home construction or a renovation project, local building codes may require a building inspector to conduct a pressure test. In order to avoid excess fees or a failed inspection, you may want to conduct your own pressure test in advance of the inspection. Even if an inspector will not be pressure testing your pipes, you can use a pressure test to verify the quality of the installation and to identify and address any problems before they become more serious. Does this Spark an idea?
Instructions
1. Prepare the system. Ideally, you should test water supply and DWV (drainage, waste and vent) pipes when the entire system is installed, but nothing is covered by drywall or otherwise inaccessible. The pipes should be dry and the main water supply turned off.
2. Block DWV pipes. To pressure test plumbing, you need to start with an airtight system. Block the vent and drain pipes at T-fittings close to the main stack, and plug all openings such as drains and fixture stub-outs. You can do this by using solvent-glued plastic caps or inflatable test balloons.
3. Connect air pump and pressure gauge. Following the manufacturer's instructions, connect the air pump and pressure gauge to your DWV line at a convenient access point, such as a cleanout fitting.
4. Pressurize the system. Run the air pump until the pressure gauge registers five pounds per square inch (PSI).
5. Monitor pressure. Check the pressure gauge periodically for at least 15 minutes. If the pressure remains unchanged at five PSI, your DWV lines are airtight and have passed the pressure test. If the pressure falls, you probably have a leak somewhere.
6. Check for leaks. Even if your pressure remains constant, you may want to trace the path of your DWV pipes and check for any signs of a slow leak, such as a soft hiss of escaping air. If the pressure falls during your test or you suspect a leak for any other reason, you can also check fittings by applying a little soapy water and watching for bubbles created by moving air.
7. Fix leaks. Once you have identified the source of any leak, you can address the problem by reseating or replacing loose or faulty fittings or compromised sections of pipe. You can then conduct a new pressure test to confirm that the problem is solved or discover what remains to be done.
8. Test water supply lines. You can generally pressure test water supply lines by simply turning on the water and checking the entire length of the system to spot any leaks, which the water pressure should reveal. If you prefer an air pressure test, however, you can follow the same steps as with the DWV pipes.
Tags: pressure test, water supply, pressure gauge, conduct pressure, conduct pressure test, pipes pressure test, pressure falls
