Studies show most household accidents occur in the bathroom which is not hard to believe when you consider the potential dangers of a slick surface. Towel bars are not designed to support weight so they're too weak to rely on. Installing a shower grab bar is a simple and inexpensive way to reduce the risk of injury when entering or exiting a shower. Does this Spark an idea?
Instructions
1. Locate the studs in the wall above the tile using an electronic stud finder. Drop a plumb line at the center of each stud and use masking tape to mark the width of the stud at the height where you will anchor each end of the grab bar.
2. Place the grab bar so that each end lies on the tape and mark all six hole locations with a pencil.
3. Use a carbide tipped drill bit to drill a half inch hole through the tile wall for a center toggle bolt. Then drill the six screw holes through the tile using a bit slightly larger than the screw diameter and remove the tape.
4. Insert a toggle bolt into its hole on the flange and fill the inside of the flange with silicone caulk. Repeat for the flange at the other end of the grab bar.
5. Position the bar on the shower wall pushing the toggle bolts into place and then insert three inch long screws into the remaining holes. Tighten the bolts and screws with a screwdriver.
6. Caulk around each flange and let dry 24 hours before using the shower.
Tags: tape mark, through tile, tile using, toggle bolt
