Air Quest Gas Furnace
It was chilly in the house in the morning. Wife turned up thermostat but no response for furnace. Checked trouble light. It was flashing 3 times witch means (pressure switch open when should be closed on single stage models. Low pressure switch open when should be closed on 2 stage VS models. My furnace is a single stage. If I shot the power off to the furnace and wait 5 minutes then turn it back on it will run ok for that cycle then start flashing the 3 code again. I checked and cleaned all the tubes that has to do with removing the condensation. They were pretty clean anyway. I call a repair man for some advise and he said to try to jump the two wires to the pressure switch and see if it works. I jumped the wires and still had the problem. Can someone help me out. Thank you
Related Posts:
Carrier furnace led codes where do i find their meaning
Carrier Furnace LED Codes - where do I find their meaning?I have a Carrier Gas Furnace 58MXA100-20 that isn't working. After reset, it's LED code blinks 1short - 2long for a while then 2short - 3l...
Armstrong air furnace having many problems
armstrong air furnace having many problems -i've an armstrong ultra v tech 80 furnace that has been working intermittently. it usually gives a 7 code [not sure what it is, but it's not the 6 then...
Carrier furnace limit switch is tripping
Carrier Furnace Limit Switch is TrippingI have Carrier Furnace model 58PAV111-20 The limit switch keeps trips after running for about 5 minutes. I can reset the switch but it trips. I looked on li...
Amana air command 80 sse gas furnace problem
Amana Air Command 80 sse Gas Furnace problemHi there. I'm having some trouble with my Amana furnace i have cleaned the sensor however it fails to blow any kindof air out cold or heat. I checked th...
Coleman gas furnace unreliable
coleman gas furnace unreliablei have a coleman gas furnace that has a spark ignition, my problem is sometimes the furnace will run normally, and other times ill come home from work and all thats r...